Informazioni normative
FCC statement
The U.S. Federal Communications Commission (in 47
cfr 15.105) has specified that the following notices be
brought to the attention of users of this product.
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Shielded cables
Use of a shielded data cable is required to comply
with the Class B limits of Part 15 of the FCC Rules.
Pursuant to Part 15.21 of the FCC Rules, any
changes or modifications to this equipment not
expressly approved by the Hewlett-Packard
Company, may cause harmful interference and void
the FCC authorization to operate this equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
Dichiarazione sul cavo di alimentazione
Il cavo di alimentazione non è riparabile.
Qualora risultasse difettoso, va gettato o restituito
al rivenditore.
Classificazione spie LED
Informazioni sulla sicurezza
Per utilizzare questo prodotto, attenersi sempre alle
precauzioni di base sulla sicurezza onde evitare il
rischio di lesioni da incendio o folgorazione.
Numero regolamentativo del modello
Il prodotto ha un numero regolamentativo del modello,
a fini di identificazione nell'ambito delle
regolamentazioni. Il numero regolamentativo di
questo prodotto è SNPRC-0305. Il numero
regolamentativo non deve essere confuso con il nome
commerciale (ad esempio HP Deskjet 9300) o con il
numero di catalogo (ad esempio C81 36A).
ITWW
DECLARATION OF CONFORMITY
according to ISO/IEC Guide 22 and EN 45014
Supplementary Information:
(1) The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC,
and carries the CE Marking accordingly.
(2) The product was tested in a typical configuration with Hewlett Packard personal computer systems.
(3) This Device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Singapore, 21
st
Nov 2002
Chan Kum Yew, Quality Manager
•
Australia Contact:
Product Regulations Manager, Hewlett-Packard Australia Ltd, 31-41 Joseph Street, Blackburn, Victoria 3130, Australia
•
European Contact:
Your Local Hewlett-Packard Sales and Service Office or Hewlett-Packard Gmbh, Department, HQ-TRE /
Standards Europe, Herrenberger Strasse 140, D-71034 Boblingen (FAX: +49-7031-14-3143)
•
USA Contact:
Corporate Product Regulations Manager, Hewlett-Packard Company, 3000 Hanover Street, Palo Alto, CA 94304
(Phone: 415-857-1501)
Manufacturer’s Name:
Hewlett-Packard Singapore (Pte) Ltd
Manufacturer’s Address:
Imaging & Printing Manufacturing Operations
20 Gul Way, Singapore 629196
declares, that the product
Product Name:
HP Deskjet 9300
Model Number:
C8136A
Regulatory Model Number:
SNPRC-0305
Product Options:
All
conforms to the following Product Specifications:
Safety:
IEC 60950: 1999 / EN 60950: 2000
IEC 60825-1: 1993+A1: 1997+A2: 2001 / EN 60825-1: 1994 Class I for LEDs
EMC:
CISPR 22: 1997 Class B / EN 55022: 1998 Class B
CISPR 24: 1997 / EN 55022: 1998
IEC 61000-3-2: 1995 / EN 61000-3-2: 1995
IEC 61000-3-3: 1994 / EN 61000-3-3: 1995
FCC Title 47 CFR, Part 15 Class B
AS / NZS 3548 / MIC-B / GB9254: 1998
ITWW